PAG MPL99 Mini PAGlink Cinergy Battery Gold-Mount - PAG-7242

PAG MPL99 Mini PAGlink Cinergy Battery Gold-Mount - PAG-7242

NEW from PAG the Mini PAGlink Cinergy Battery.
THE INTELLIGENT LINKING SOLUTION FOR HIGH-VOLTAGE CAMERAS

FEATURES
Use your MPL batteries to power both 14V and 28V cameras.
• Link the Cinergy Battery with any MPL battery in a similar state of charge to achieve high voltage.
• The sensor and barcode label system safeguards against low-voltage equipment being powered with a high-voltage combination.
• Safe, low-power, infrared communication does not generate RFI.
• Voltage output is always the sum of 2 MPL batteries linked in series, regardless of how many are in the stack.
• Once removed from the barcode, the battery reverts to low-voltage mode and can be charged with a standard 14V charger.
• In low-voltage mode the Cinergy Battery can be linked to other MPL batteries to increase capacity, run-time and current-draw (from 10A to 12A).
• In low-voltage mode, seamless hot-swapping for continuous power is possible.
• Up to 10 MPL batteries can be linked to each charging position for more efficient charging.
• Safer handling and increased durability due to ergonomic design, ‘soft-touch’ coated band and protection ‘bumpers’.
• 1/4” bush inserts for mounting accessories.
• An accurate, numeric display which shows run-time on-load, state-of-charge at any time, and data to assist with battery management.
• Communication with multiple camera data systems that display state-of-charge in the viewfinder/LCD.
• New modular construction that allows easier servicing, authorised replacement of the cell- pack and reuse of modules for greater sustainability.
• Flight-friendly 99Wh capacity and independently tested to UN 38.3 standard.

The new Cinergy Battery can be linked with any MPL battery in series, combining the voltage output to power high-voltage equipment, such as the Arri Alexa 35.

Like standard MPL batteries, it can also be linked in parallel, combining capacities, and increasing run-time and current-draw for powering low-voltage equipment.

The Cinergy battery will switch to high-voltage mode
when its infrared sensor reads a barcode label applied to the equipment’s battery mount (it must also be linked to another MPL battery). Once removed from the barcode, it reverts to low-voltage mode, suitable for charging with a standard 14V charger.