SKU
DHY-03T

Sonifex DHY-03T Twin Automatic Digital Telephone Hybrid (Rack Mounted)

£1,987.14 £1,655.95
Did you find this item priced lower than £1,655.95 somewhere else? Yes

Sonifex DHY-03T Twin Automatic Digital Telephone Hybrid (Rack Mounted)

Twin Automatic Digital TBU, Rack Mounted

 

The DHY-03T is a twin automatic digital TBU, 19" (48.3cm) 
rack-mount unit.

The digital DHY-03 telephone hybrid is probably the best performing digital hybrid in the world, with simply stunning line balance rejection figures. For the best sounding audio calls you’re likely to hear, you should specify the DHY-03.

The DHY-03 has the following features :

  • Fully automatic - adapts to varying line conditions and has automatic signal limiting.
  • Fully adaptive echo cancellation to 127msec - default is 24msec.
  • 76dB typical line balance rejection offering superb performance and crystal clear audio.
  • Front panel input and output gain controls.
  • Front panel LED metering of receive and send signals.
  • Built-in conferencing for 2 hybrids, so that a single telco channel on a mixing desk can receive 2 calls.
  • Integrated ring detector - automatic call answering after a pre-determined number of rings.
  • Automatic call disconnection. Fitted with K-break, line polarity reversal and dial tone disconnect detection, defined by the country selection.
  • Automatic ducking facility allows the talent to ‘shout-down’, or talk over, a caller by reducing the gain of the caller’s signal if it goes above a certain level.
  • Local and remote line hold switching - calls can be remotely switched through a mixing console.
  • Line hold/release button to control line hold circuit, illuminates to indicate the status of the line and flashes to show ring status.
  • DTMF tone recognition allowing a opto-isolated GPI output to be made on receipt of selected DTMF tones, e.g. for starting a studio automation recorder automatically to record a remote telephone interview.
  • International operation with built-in configurable settings for each country. Country selection allows the unit to provide line impedance and a simulation circuit to match the country.
  • RS232 serial port for remote control of the TBU, DTMF tone dialling and firmware upgrades to add new country settings.
  • Remote port distributes the remote line connect switch and tally output, a momentary/latch selector and the DTMF detect output.
  • The remote line connect switch can be either momentary or latching in its action.
  • Balanced mic/line input - 10k balanced input selectable for 0dBu clean feed line, or microphone level with adjustable gain.
  • Balanced output - 0dBu low impedance balanced output, with output gain settings.
  • Record output - the conferencing output can be set via a jumper to give a mix of the caller and mic/line input signals for recording both sides of the telephone conversation.
  • Line limiter, bandpass filter and output noise gate with preset threshold providing low distortion audio.
  • Built in universal power supply between 90V AC and 250V AC, 47-63Hz, IEC mains input.
  • ETSI approval compliant with European PTT specifications.

SCi logoThis product has settings that can be adjusted using the Sonifex SCi (Serial Control Interface) software. To download a copy of the SCi software, please use this link >

Technical Specification For DHY-03

Audio Specification

Input Impedance - Line Mode (Clean Feed): 10kΩ balanced 0dB
Input Impedance - Conferencing: 10kΩ balanced 0dB (not for DHY-03EC)
Input Impedance - Microphone Mode: 2kΩ balanced (not for DHY-03EC)
Input Level Gain Range: +6dB, 0dB, and -6dB adjusted by 3-position front panel switch, 
+10dB jumper
Microphone Level Gain Preset: From 65dB to 35dB (not for DHY-03EC)
Maximum Input Levels: Line +26dBu, mic -24dBu
Clean Feed Limiting Input: -4dBu for CTR21 setting, other values available *
Bandwidth to Telephone Line: 250Hz - 4kHz, -3dB ref 1kHz
Telephone Line Impedance: 600Ω, 900Ω plus 14 other complex impedance circuits *
Output Impedance - Line Out: 50Ω balanced floating 0dBu
Output Impedance - Conference/Record: 50Ω balanced floating 0dBu
Output Level Gain Range: +6db, 0dB, and -6dB adjusted by 3-position front panel switch
Rejection Ratio: 76dB on tones or complex waveforms, reference peak level of 0dB
Ring Detector Sensitivity: Off, 2, 4 or 6 rings
Power to DHY-03, S & T Universal 12Ω power supply: 90 to 250V AC; 47-63Hz; fused 1A
Power to DHY-03EC ±15 V DC @ 160mA per rail or regulated +5V DC @ 600mA
* These values are dependent on the actual country setting selected on the DHY-03
   

Connections

Mic/Line Input: XLR 3 pin female, with push-button mic/line selection
Line Output: XLR 3 pin male
Telephone Line: RJ11 6/4 socket
Telephone Handset/Instrument: RJ11 6/4 socket
Conferencing or Record Audio: RJ45 socket
Remotes: 9-way D-type socket
RS232 Serial: 9-way D-type socket
Power: IEC mains (CEE22)
Connections for Eurocard 64 pin DIN 41612 male (plug)
Each DHY-03, S & T unit is supplied with 1 x RJ11 to RJ11 telephone line lead, 1 x RJ11 to BT plug telephone line lead, 1 x BT handset socket to RJ11 plug adapter, IEC mains lead fitted with moulded mains plug, handbook and warranty card.
 

Physical Specification

Order Code     Description
Height
Width
Depth*
Total Nett
Weight
Total Gross Weight
DHY-03T     Twin automatic digital TBU, 19” (48cm) rack mounted
4.5cm (1U)
1.8” (1U)
48.3cm
(19” rack width)
17.5cm
6.9”
2.80kg
6.2lbs
4.4kg
9.7lbs
      DHY-03T boxed
6.8cm
2.7"
58.8cm
23"
27cm
10.6"
   
*Depth is measured from the front to the end of the connectors fitted to the back of the unit.
   

Accessories

Order Code     Description
DHY-03CON     Front Panel Conversion Kit, DHY-03S to DHY-03
DHY-03SCON     Front panel conversion kit, DHY-03 free standing to DHY-03S 
19” (48cm) rack-mount front
DHY-03TCON     Front panel conversion kit, DHY-03 or DHY-03S, to DHY-03T 
19” (48cm) rack-mount front
DHY-03CONF     Conference Cable to Connect 2 x DHY-03 Units
DHY-03RLY     Latching Handset Relay Option for DHY-03, S and T